Quickie Groove Technical Information PDF herunterladen (Seite 49)

Quickie Groove 49

.EMS

4. REMOVE OLD LABEL, RWD-FWD, (Fig.13.48).

Remove tie-down label from the frame (RWD, FWD) only when

you have lift, tilt or lift & tilt module.

13.16 Rear Tie-down Brackets onto all Groove Seat

Interfaces – Kit P/N 015604, 015605 and 015544

Tools required to fit rear tie-downs to all Groove seat

interfaces:

• 10 and 13mm combination spanner

• 5mm hex (Allen) wrench

• 4mm hex (Allen) wrench

1. RELOCATE TRACK, (IF FITTED), (Fig.13.50)

Interface holes 0 and 1 need to be free

Remove M6 screw, washer and nut from track bracket. Relocate

track bracket in next available space after hole 2. Secure track

bracket

2. REMOVE MODULE SCREW, (Fig.13.51)

If rear of module is secured in hole 2 remove M8 screw. If rear

of module is secured in hole 3 proceed to step 4.

3. FIT REAR TIE-DOWN BRACKET, (Fig.13.52).

Secure rear tie-down bracket with M8 module screw and 1 M8

x 20 screw and nut (from kit). Proceed to step 5.

4. FIT REAR TIE-DOWN BRACKET, (Fig.13.53).

Secure rear tie-down with 2 M8 x 20 screws and nuts.

5. FINAL ASSEMBLY, (Fig.13.54).

Apply tie-down label (correct orientation). Repeat process for

opposite side of chair.

Fig. 13.48

Fig. 13.49

Fig. 13.50

Fig. 13.51

Fig. 13.52

Fig. 13.53

Fig. 13.54

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 65 66

Keine Kommentare

Quickie Groove Technical Information Seite 49