Quickie Pulse Wartungshandbuch PDF herunterladen (Seite 42)

PULSE 6 SERVICE MANUAL

PAGE 5.8

SEPT 2011 SUNRISE MEDICAL

Warning: Use caution in the next step. Do not short the leads of the Multimeter together

or damage may occur to the control module.

6. At the 6-pin connector on the cable leading to

the control module, verify that battery voltage is

present between the indicated pins (ﬁ gure 5.8.1).

Note: The polarity of the voltage is not important

since it is reverses when the opposite direction is

selected.

7. If voltage is not present, replace the cable

leading to the control module. If this does not

solve the problem, replace the control module.

Refer to Control Module Removal section of this

manual. Retest as necessary.

8. At the 6 pin connector "B" (ﬁ gure 5.8.2) on

the rear of the tilt, check continuity between the

indicated pins (ﬁ g. 5.8.3).

R-net Fault Codes cont.

fig. 5.8.1

fig. 5.8.2

fig. 5.8.3

Section 5

1 to 3 ohms

Voltage to

the actuator

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 71 72

Keine Kommentare

Quickie Pulse Wartungshandbuch Seite 42