Quickie Hula Technical Information PDF herunterladen (Seite 19)

HULA 19

Rev.1.0

5.7 Armrests

5.7.1 Armrests-ip up

The armrests on both sides of the wheelchair can be

flipped up to allow side transfer, (Fig. 5.11-5.12).

For side transfer flip the armrest all the way up until it

goes into its mechanical stop. This frees your space for

side transfer.

To bring the armrests back into their position flip it all the

way down until it sits on its mechanical stop. Guide it in its

downward movement and do not let it fall on its own.

5.7.2 Armrest Height Adjustment

The following section outlines armrest height adjustment.

In the case of either fine or coarse adjustment, it is a

two-part process:

PART I: Adjust the armrest height through rotation

PART 2: Adjust arm pad angle.

1.Basic fine adjustment.

PART 1 (fig. 5.13 & 5.14)

Up to one inch of armrest height adjustment can be

achieved using the 5mm fine height adjustment screw to

fine tune the armrest’s height.

Loosen the 6mm rotation bolts on both armrests (A).1.

Turn the adjustment screws (B) counter-clockwise to 2.

raise the armrest or clockwise to lower.

Retighten both rotation bolts (A).3.

Tighten (A) 20 Nm or 177lbf/in of torque.

PART 2 (fig. 5.15 & 5.16)

Loosen the 4mm armpad angle pivot bolts (A) on both 1.

armrests. Remove the 4mm angle index bolts (B) on

both armrests.

Tilt both arm pads down (or up in the case of a 2.

lowered armrest) until the arm pads are in the

preferred angle. Check to see if the height is correct.

Retighten both armpad angle pivot bolts (A). Replace 3.

both armpad angle index bolts (B).

Tighten (B) to 10 Nm or 88.5lbf/in of torque for both sets

of bolts.

Fig. 5.14

Fig. 5.16

Fig. 5.11

Fig. 5.12

Fig. 5.13

Fig. 5.15

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Quickie Hula Technical Information Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Roller Quickie Hula